How To Repair Vertical Blind Chain Pull Cord

How to Restring a Vertical Blind Headrail

Introduction

When the string on your vertical blind becomes frayed or breaks completely, it is necessary to restring the blind. These instructions show how to restring your vertical blind headrail. The blind shown is a common vertical blind with a one-way draw. The parts in your bullheaded may wait unlike, just the techniques shown volition use.

A Note on Safety

Kids tin can strangle in blind cords. To brand your blinds safer for kids, keep cords out of reach and secure cord and bead chain loops. To learn more, delight visit our child prophylactic guide.

Tools Needed

Pair of scissors

Phillips Screwdriver

Needle Nose Pliers

Lighter

Parts Needed

Step 1 – Measure the bullheaded.

Use the following formula to determine the amount of string needed:
2x the width of the blind + 2x the length of the blind + 5 ft.
Cutting the length of string needed.
Remove your slats from the blind by using a flat object like a plastic bill of fare to release the slats from the clips.

Step 2 – Remove the headrail by pushing up on the subclass tabs on the backside of the blind. Place the headrail on a flat surface.

Remove whatsoever cord weight or tensioners from the blind concatenation or string.
Pull the string free from the blinds with your pliers.
Cut the ends knots off of the cord.

Step three – Employ the lighter to melt an terminate of the new cord to the old cord.

Curlicue the cord to meld the ends together.
Pull the cord through the blind.

Step four – Tie a knot at the terminate of the new cord so information technology won't pull through the blind.

Cut off the old cord.
Tie a knot and cut whatever excess cord.

Step 5 – If your cord is completely missing or broken, remove the control terminate.

Use the wire restring tool to feed the cord through the carriers and command stop.

Footstep half-dozen – Feed your string through the eye of the wire and pull through.

Feed the cord around the wheel on the idle finish.

Stride 7 – Feed the wire restring tool through the last carrier. Pull the string through, and tie a knot.

Feed the wire back through the carriers and control terminate.
Pull the cord through the control end.

Step 8 – Insert the wire through the other pigsty in the last carrier, and pull the string through.

Tie a knot, and cut any excess cord.
Examination your repair by pulling the cord.

Stride 9 – Some carriers vary on the brand and may have different cord paths.

If the cord needs to be fed through a small hole, melting the cease of the cord will prevent fraying.
Feed the cord through the carrier, and tie a knot at the terminate of the cord.

Pace 10 – Reattach the control end.

Stride 11 – Reattach whatever cord weights or tensioners to the cord and chain. It's of import to keep all loops tied down securely for child safe reasons.

If necessary, adjust the length of the string by pulling the cord through and tying a new knot.
Reattach your blind to the brackets by inserting the front of the headrail into the subclass and rotating the headrail up and back.

Step 12 – Reattach your vanes to the blind.

Pace xiii – Exam the repair by pulling the blind open and closed.

String Path Diagram

Source: https://fixmyblinds.com/pages/how-to-restring-a-vertical-blind-head-rail

Posted by: martinezwitow1947.blogspot.com